|
|
Thermal Angel Blood and IV Fluid Infusion Warmer Quick Steps
To see the Thermal Angel video (Click Here)
Step 1:
-
Remove the female luer cap from the inlet end of the Thermal Angel.
-
Connect IV tubing to the female luer. Tighten until resistance is met. Do not over tighten!
Step 2:
-
Remove the male luer cap from the outlet end of the Thermal Angel.
-
Connect 9 Inch IV Extension Set to the male luer. Tighten until resistance is met. Do not over tighten!
Step 3:
-
Connect assembled IV line to fluid source and prime the line.
Step 4:
-
Connect the male end of the Power Cable to the inlet end cap of the Thermal Angel.
-
Connect the female end of the Power Cable to the Battery.
-
The green LED on the Thermal Angel inlet end cap should display continuous illumination without blinking.
Step 5:
-
Connect 9 Inch IV Extension Set to IV catheter.
-
Engage roller clamp on IV tubing to adjust flow.
To see the Thermal Angel video (Click Here)
To see Detailed Instructions (Click Here)
|
|
Contact Us
